marc:cisco
This is an old revision of the document!
Table of Contents
Networking
Cisco configuration
Initial switch configuration
- Connect PC to switch using parallel/console connection
- Open terminal emulation program (i.e. Putty)
- Use serial connection (check Windows device manager - Ports(COM & LPT) to check which port to use)
- Speed: 9600
- Press connect
- If the switch has not been configured (or has had a factory reset) you're asked to enter the initial configuration dialog; type no!:
- Initial mode is user mode (Switch> prompt)
- Typing enable gets you into privilege mode (Switch# prompt)
- Typing ? shows available commands
- Tab completion is available but if it's clear that only 1 command is available, finishing it is not necessary.
Initial router configuration
marc/cisco.1708789999.txt.gz · Last modified: by marcv